Please enable JavaScript to view this site.

User guide

A "Special function" is a special command that will instruct the embroidery machine to perform a special action. Inside the software there are two available "Special functions", "Trim" and "Stop" and they are available only when the Sequence is "Manual" mode.

Thread trim

This special function instructs the embroidery machine to make a pause, cut the thread and then start embroidering again. To add a "Trim" special function you have to select the object that will become also selected in the Sequence manager. Then you have to right click on it in the Sequence manager and expand the "Trim" option. By default it is set to "Auto". To enable the "Trim" special function you have to set it to "On".

If an object has a "Trim" Special function applied, the relative icon will appear next to the object on the Sequence manager.

If you set the "Trim" Special function to "Auto", then the software will decide if it will add a thread trim or not, based on the settings of the "Optimizer options" dialog. If the software decide to add a thread trim on an object you will see the "Auto" icon next to the object, so you will know that the embroidery machine will make a thread trim before sewing out the object. If you do not want the Auto thread trim to happen you can either change the settings in the "Optimizer options..." or set manually the "Trim" to "Off". If you set it to "Off" the following icon will appear next to the object.

Stop

This special function instructs the embroidery machine to Stop, there are things that can’t be done automatically by the embroidery machine, the machine makes a stop and waits until you press start. To add a "Stop" special function you have to select the object that will become also selected in the Sequence manager. Then you have to right click on it in the Sequence manager and expand the "Stop" option. By default it is set to "Auto". To enable the "Stop" special function you have to set it to "On".

If an object has a "Stop" Special function applied, the relative icon will appear next to the object on the Sequence manager.

If you set the "Stop" Special function to "Auto", then the software will decide if it will instruct the machine to stop or not, based on the settings of specific stitch types(Appliques). If you do not want the stop to happen you can set manually the "Stop" to "Off". If you set it to "Off" the following icon will appear next to the object.